TMCnet - World's Largest Communications and Technology Community



It's got to end eventually ... [Telegraph-Herald (Dubuque, IA)]
[March 09, 2014]

It's got to end eventually ... [Telegraph-Herald (Dubuque, IA)]

(Telegraph-Herald (Dubuque, IA) Via Acquire Media NewsEdge) Though you shouldn't put them away just yet,, an online store for replacement parts for home appliances, outdoor power equipment and heating and cooling equipment, has released a list of how-to tips to get snowblowers ready for storage.

"It's important to take the time to prepare snowblowers for storage," said Jeffrey Linderman, outdoor power equipment specialist for "Just a few simple maintenance steps will extend the life of your snowblower and ensure that it runs well when you need it again." 1 Replace the spark plug.

The tiny but mighty spark plug should be replaced at least once per season, even if it appears to be working fine. Over time, a spark plug's performance will degrade due to carbon buildup and a weakened electrode. This dramatically increases emissions, reduces engine performance and increases fuel consumption.

2 Drain and replace the oil.

Before replacing engine oil, check your owner's manual for the recommended way to tilt the snowblower. It varies from model to model.

Unscrew the drain plug and release the oil into a bucket. Replace the plug and add fresh oil, as recommended by the manufacturer.

Used oil should be recycled. Most small engine repair shops have a free recycling program for this.

-- Add fuel stabilizer to fresh fuel.

Fuel stabilizer slows buildup in the carburetor.

Follow the owner's manual for instructions on leaving fuel in the engine during storage, as this varies by manufacturer.

4 Degrease.

Spray a degreaser on greasy and dirty areas.

Allow the degreaser to sit for 10-15 minutes before wiping with a clean cloth.

5 Check the fuel cap and tires.

Fuel caps have small vent holes to allow air into the fuel tank.

Replace the fuel cap if its air vent holes are blocked by buildup or debris.

Cover or close the fuel cap vents.

Check the tires for wear and replace as needed.

For pneumatic tires, a tire pressure gauge should be used to check the air pressure.

6 Lubricate bearings.

Lubricate wheel bearings, auger bearings and the impeller bearings.

7 Inspect the scraper blade, slide shoes and other parts for wear.

Thoroughly check the scraper blade and slide shoes (a.k.a. skid shoes) for wear.

These parts have the important job of protecting the housing from damage. Replace these parts if they have worn dangerously thin or are damaged beyond repair.

8 Store in a cool, dry place.

Cover the snowblower to prevent dust and debris from entering the unit.

"While you're preparing the snowblower for storage, it's a good idea to also get a jump on prepping your spring outdoor power equipment such as lawn mowers, string trimmers, etc." Linderman said. "A tune-up kit with air filters, oil and other maintenance essentials make it convenient." Tune-up kits for small engines can be found at tune-up.

(c) 2014 ProQuest Information and Learning Company; All Rights Reserved.

[ Back To's Homepage ]

Technology Marketing Corporation

35 Nutmeg Drive Suite 340, Trumbull, Connecticut 06611 USA
Ph: 800-243-6002, 203-852-6800
Fx: 203-866-3326

General comments:
Comments about this site:


© 2018 Technology Marketing Corporation. All rights reserved | Privacy Policy