TMCnet News
Synopsys Launches HAPS-70 Series FPGA-based Prototyping SystemsNov 15, 2012 (Close-Up Media via COMTEX) -- Synopsys, Inc., a provider of software, IP and services used in chips and electronic systems, announced the availability of Synopsys' HAPS-70 Series FPGA-based prototyping systems, extending its HAPS product line to address the increasing size and complexity of system-on-chip (SoC) designs. According to a release, the HAPS-70 systems provide tightly integrated prototyping software and hardware, including high-speed time-domain multiplexing (HSTDM) technology, which in combination with new HapsTrak 3 I/O connectors delivers up to 3x prototype performance improvement over traditional connector and pin multiplexing technology. The new prototyping systems take advantage of a scalable architecture and the latest generation Xilinx Virtex-7 FPGA devices to support a range of design sizes with capacities from 12 to 144 million ASIC gates. The flexibility and matched pin connections between the Virtex-7's I/O banks and HapsTrak 3 connectors enable HAPS users to utilize I/O bandwidth where it is needed most while minimizing the number of unused pins. "The stacked silicon interconnect technology of the Virtex-7 2000T FPGA delivers two million logic cells of capacity and 12.5 Gb/s serial transceivers, making it ideal for ASIC prototypes which require both high capacity and high-speed I/O," said Tim Erjavec, VP of FPGA platform marketing at Xilinx. "The Synopsys HAPS-70 Series takes advantage of the Virtex-7 2000T FPGA's increased design capacity and I/O bank organization to deliver a system that eases design planning within and across multiple FPGAs while allowing the HAPS-70 to scale up to support multi-million gate ASIC SoC designs." The company noted that HAPS-70 systems are integrated with an intelligent prototyping software environment that enables faster partitioning and automates the creation and debug of prototypes for a range of designs from individual IP blocks and processor sub-systems to complete SoCs, easing the path from RTL to operational prototype. The modular architecture of the HAPS-70 systems enables engineers to use a common prototyping environment for IP and SoC software development, hardware/software integration and system validation, reducing duplication of effort across projects. New "HAPS-aware" features of Synopsys' Certify multi-FPGA prototyping software increase prototyping productivity by up to 10x with patent-pending algorithms to automate logic partitioning and live hardware queries to ease system bring-up compared to manual partitioning methods. The new prototyping systems also support HAPS Deep Trace Debug for greater debugging efficiency, providing approximately 100 times more signal storage capacity than the traditional memory storage employed by on-chip FPGA logic debuggers. For easier system validation and software development, DesignWare Interface IP such as USB 3.0, PCI Express and HDMI are validated on HAPS systems. With pre-validated DesignWare IP on HAPS systems and a rich selection of daughter cards for common IP protocols, designers can start software development earlier in the product development cycle and reduce IP integration effort. "Synopsys' HAPS FPGA-based prototyping has been invaluable to Mindspeed for accelerating our hardware/software validation and improving our prototyping productivity," said Surinder Dhaliwal, executive director, VLSI Core Engineering, at Mindspeed Technologies, Inc. "As we continue to develop infrastructure product solutions, we are pleased that Synopsys has enhanced its FPGA-based prototyping family with higher performance, greater capacity and improved debug visibility targeted at larger, more complex designs like ours." More Information: synopsys.com ((Comments on this story may be sent to [email protected])) |