[August 24, 2012] Kemet Launches New Line of Polymer COTS Capacitors Tweet Aug 24, 2012 (Close-Up Media via COMTEX) -- Kemet Corp., a manufacturer of tantalum, ceramic, aluminum, film, paper and electrolytic capacitors, introduced its new line of polymer Commercial Off-the-Shelf (COTS) capacitors. According to a release, the T543 Series offers over 300 discrete part numbers not including termination, ESR and surge current options. This extensive offering provides designers with the tools necessary to customize their capacitance solutions and maximize application performance. "The features of the T543 Series will allow our customers to use up to 90 percent fewer capacitors, providing the lowest cost solution for power management," said Dr. Philip Lessner, KEMET Senior Vice President, Chief Technology Officer and Chief Scientist. "Low ESR characteristics and outstanding power dissipation results in ripple current that is three times higher than the equivalent MnO2 capacitor." The T543 Polymer COTS Series utilizes the designs of Kemet's commercial polymer product with the addition of 24 hours minimum of voltage conditioning and surge current options at +25 degrees C and -55 degrees C/+85 degrees C," stated Ed Jones, Kemet Specialty Tantalum Product Manager. "This upscreening, combined with a benign failure mode, assures the design community of long term reliability and worry-free performance." Typical applications include radar pulse capacitor, point of load supply and switch mode power supply in the computer, industrial, defense and telecommunications markets. More information: www.kemet.com ((Comments on this story may be sent to [email protected])) [ Back To TMCnet.com's Homepage ]